Staywell Pet Door - 300, 400 & 500 Series
Before installing your cat flap please read the fitting instructions supplied with your cat flap carefully.
|
Tools required - Pencil, Ruler, Jig or key hole saw, Drill, Set square, Screwdriver, Tape Measure, Glue | |
| Measurement and marking | ||
|
Measure the belly height of your cat. This is usually 100 - 150 mm ( 4" - 6") | |
| i | ||
|
Mark this measurement on the outside of your door and draw a straight horizontal line 168mm (6 12") | |
| Cutting a hole for your cat flap | ||
|
a) In wood
Using the horizontal line as the starting point, draw a square 168mm wide x 175mm high. | |
| i | ||
|
Drill holes at each corner | |
| i | ||
|
Cut along the lines using a jigsaw | |
| i | ||
|
Smooth out the rough edges | |
| i | ||
|
b) In Glass
Using the horizontal line as the base, cut a circular hole to a diameter of 212mm. | |
| i | ||
|
It is not possible to cut hole in toughened glass or double glazing units except at the time of manufacture. 400 series will only operate in double glazing if a plastics spacer bar is used. If a metal spacer bar is used it must be left unjoined. Cutting holes in glass can be hazardous. We advise you to consult your local glazier | ||
| i | ||
| i | c) In Metal
Catflaps 300 & 500 Series Follow the instructions for "Cutting a hole for your catflap in wood" | |
| i | ||
|
400 Series
The cat flap will not operate if fitted to a door containing metal e.g. uPVC coated metal doors, metal skin doors or security doors. The catflap must be isolated from the metal in a wood frame. Using the horizontal line, draw a square with minimum dimensions of 306mm x 306mm. Cut along the lines with a jigsaw. | |
| i | ||
|
Fit a wood frame to the hole with internal dimensions of 168 mm wide 175mm high. | |
| i | ||
| i | d) In walls
Follow the instructions for "Cutting a hole for your catflap in wood" | |
| i | ||
|
Staywell Cat flaps are designed to fit any depth hole. It is recommended that the tunnels be glued onto the frame. Simply attach tunnels to the required depth. | |
| i | ||
|
Your Staywell cat flap is fitted with the red 4 way lock on the inside of your door. Place the cat flap in the hole and mark screw holes in the outside cover in pencil | |
| i | ||
|
Remove the cat flap and drill the holes with a 4.5mm drill bit. | |
| i | ||
|
Screw into place and if needed cut the screws down to size and file to ensure no sharp edges. Cover the screw holes with the blanking plugs supplied to ensure a neat finish. Push fit the 4-way locking handle into place.
Your Staywell cat flap is now ready to use. | |
| i | ||
| Magnetically operated cat flaps 400 Series | ||
|
The fixed tunnel is an integral part of the mechanism and must not be cut or damaged as it will effect the operation of the latching mechanism. Operated by magnetism and requires no batteries | |
